Hi,
I managed to melt one of the fuel lines while welding in some roll cage footplates. :roll:
I have removed the old plastic line and am trying to fit a spare I had to the metal part.
It was left it in boiling water for ten minutes before fitting it and have lubed up the pipe to get it started.
I have managed to get it so far using a hairdryer to heat it up then try to push it further on but it needs to move by maybe an inch more but I can't seem to move it any further.
Any hints or tips from people who have done this in the past please?
Cheers,
Ben.
I managed to melt one of the fuel lines while welding in some roll cage footplates. :roll:
I have removed the old plastic line and am trying to fit a spare I had to the metal part.
It was left it in boiling water for ten minutes before fitting it and have lubed up the pipe to get it started.
I have managed to get it so far using a hairdryer to heat it up then try to push it further on but it needs to move by maybe an inch more but I can't seem to move it any further.
Any hints or tips from people who have done this in the past please?
Cheers,
Ben.