Hi,
A call to the collective brain of knowledge and advise (again).
Power steering leak, corroded pressure pipes , found replacement pipe on line with help of member on this site (thanks again) so it arrived and I noticed they was not any unions with it for fitting to the pump and rack, one listed on eBay stated they are nut size 21mm,ones on my car are 18mm, anybody out there have the correct part number and supplier? also what is involved with fitting these unions, is it 'push' into the union then tighten, or tighten the union then 'push' in?
Also access looks a tad tight, been advised is an engine out job, surly not?
Thanks for everyone's time and help.
Brgds
D
A call to the collective brain of knowledge and advise (again).
Power steering leak, corroded pressure pipes , found replacement pipe on line with help of member on this site (thanks again) so it arrived and I noticed they was not any unions with it for fitting to the pump and rack, one listed on eBay stated they are nut size 21mm,ones on my car are 18mm, anybody out there have the correct part number and supplier? also what is involved with fitting these unions, is it 'push' into the union then tighten, or tighten the union then 'push' in?
Also access looks a tad tight, been advised is an engine out job, surly not?
Thanks for everyone's time and help.
Brgds
D
