Powder coat sump

ProjectPuma

Help Support ProjectPuma:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

marco.da.man

Member
Joined
Oct 23, 2015
Messages
92
Location
Mid Glamorgan
Hi guys

I was wandering if any off you has ever had there sump powder coated and if so what steps did you take before it went to powder coaters ?
 
Had mine done, no prep just gave it to them, they did sandblast it then paint it with zinc primer before coating it, any good powdercoaters will do the prep for you, one bit of advice: more is cheaper with powdercoaters, one or two small bits will cost a bomb, but if you do a whole pile of stuff it gets cheaper, I got two engine brackets done cost £70, then I had both wishbones, front subframe, and 4/5 other bits and it cost £200
 
yeah already had aload off bits done by him and found that out as had quiet a bit of stuff done
 

Attachments

  • Engine Mount, Bumper Bracket and Other Bits.jpg
    Engine Mount, Bumper Bracket and Other Bits.jpg
    123.2 KB · Views: 1,868
  • Front Sub Frame.jpg
    Front Sub Frame.jpg
    82 KB · Views: 1,868
  • Gear Box MOunt, Rear Axel Bracket, Suspension Tops and few other bits.jpg
    Gear Box MOunt, Rear Axel Bracket, Suspension Tops and few other bits.jpg
    146.1 KB · Views: 1,868
  • Knuckles, Rear Drum Plates, Caliper Bracket, Engine Brackets Etc.jpg
    Knuckles, Rear Drum Plates, Caliper Bracket, Engine Brackets Etc.jpg
    162.4 KB · Views: 1,868
  • Rad Bracket.jpg
    Rad Bracket.jpg
    162.9 KB · Views: 1,868
  • Rear Frame.jpg
    Rear Frame.jpg
    80.9 KB · Views: 1,868
  • Wheel Tray.jpg
    Wheel Tray.jpg
    133 KB · Views: 1,868
  • Wishbones.jpg
    Wishbones.jpg
    158.4 KB · Views: 1,868

Latest posts

Back
Top