demonskull13
New member
so i decided to clean my door catches up today getting readyer for the ford fair if doing this please follow photos because you could loose the braket it bolts to so here it is dirty catch
dirty catch
take one bolt out DONT TAKE BOTH OUT
loosen second bolt and swing catch on other bolt then put thirst bolt in to hold the piece it screws in to
then take off catch leaving bolt in and clean up
clean catch up
put bolt through the top bracket hole and screw in slightly
then take bottom bolt out and put through the bottom of the bracket
then tighten both evenly you should still be able to see where it used to fit
then close door and reopen see if it is lined up when lined up tighten down and thats it job done
hope this helps people just remember the plate it screws into is loose and only those bolts holding it so must at all times have one thats slightly in
:thumbs: ose: k:
jason
dirty catch
take one bolt out DONT TAKE BOTH OUT
loosen second bolt and swing catch on other bolt then put thirst bolt in to hold the piece it screws in to
then take off catch leaving bolt in and clean up
clean catch up
put bolt through the top bracket hole and screw in slightly
then take bottom bolt out and put through the bottom of the bracket
then tighten both evenly you should still be able to see where it used to fit
then close door and reopen see if it is lined up when lined up tighten down and thats it job done
hope this helps people just remember the plate it screws into is loose and only those bolts holding it so must at all times have one thats slightly in
:thumbs: ose: k:
jason