door catches

ProjectPuma

Help Support ProjectPuma:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

demonskull13

New member
Joined
Jun 14, 2014
Messages
434
Location
worcester
so i decided to clean my door catches up today getting readyer for the ford fair if doing this please follow photos because you could loose the braket it bolts to so here it is dirty catch

dirty catch

take one bolt out DONT TAKE BOTH OUT

loosen second bolt and swing catch on other bolt then put thirst bolt in to hold the piece it screws in to

then take off catch leaving bolt in and clean up



clean catch up

put bolt through the top bracket hole and screw in slightly

then take bottom bolt out and put through the bottom of the bracket

then tighten both evenly you should still be able to see where it used to fit

then close door and reopen see if it is lined up when lined up tighten down and thats it job done

hope this helps people just remember the plate it screws into is loose and only those bolts holding it so must at all times have one thats slightly in

:thumbs: :pose: :eek:k:


jason
 
Good job. Handy to know, I would have just unscrewed them both and watched the plate the other side drop into the rear quarter :lol:
 
moondustka said:
[post]354089[/post] Good job. Handy to know, I would have just unscrewed them both and watched the plate the other side drop into the rear quarter :lol:

good to know that it helped you and others

:thumbs: :pose2: :eek:k:
 

Latest posts

Back
Top