Detango Rear Lights

This section will mainly be used to provide useful guides for everything from changing your steering wheel to fixing that damn parcel shelf!

Moderator: Moderators

Post Reply
User avatar
YOG
Guru!
Guru!
Posts: 2190
Joined: Tue Feb 26, 2008 11:38 pm
Model: Thunder
Location: West Sussex

Detango Rear Lights

Post by YOG » Mon Jul 31, 2017 11:29 pm

Posted by Jasper on Tue May 13, 2008

Ever since I'd seen this picture,
5837

I'd been playing with the idea of adapting the rear lights to a clear/red/clear setup, and on Friday, I ordered a pair of rear lamps from a local scrapyard.
5843

They arrived on Monday morning and I spent a bit of time working out what the best way of taking them out would be. I wanted them to look good but also wanted to avoid any water ingress into them.
So, I thought it would be better not to remove the light lens, but to cut them out from the back, in such a way that it's easy to glue them back together.
I got out a junior hacksaw blade to work out where to cut a hole big enough to fit the lens through. 5 minutes later I had my answer.
5838
5839

It really helps that you need 4 rear lights to make two, because that gives you two to practice on before you remove the lamps from your car (3 x 10 mm nuts hold each lamp on, take them off and disconnect the bulb holders and it'll come free).
5 minutes later it'll look like this.
5840

And from the front, like this.
5841

The orange lens are just held in with a clip at both sides and should slide out of the hole with a wee tug. I then washed out the inside of the lamp with water as there was a lot of plastic fragments in it. The white lens (which you'll have broken out of their lamps and are sided), should pop through the hole and with a bit of fiddling, pop into place. Then with a splodge of glue, secure the cut out parts back into their casings.

Leave it for five minutes to set and you are good to put them back in your car. Remember to change the bulbs to orange ones or silver bulbs that flash orange (like I have). These are available from VW for £9.57 each, part number N10256404 or from ebay.

Then you too will have sexy lights like these.
5842
1 x
Rick

Haynes Fiesta Manual (3397) answers a lot of your questions: http://www.projectpuma.com/viewtopic.php?f=6&t=5259"

S/Steel BlueFlame Catback Exhaust. Denso Iridium Spark Plugs. ST150 Front Brakes. S/Steel Braided Brake Lines. Eibach Springs/KYB Shock Absorbers. Heated Washer Jets. Internal Boot Release. Glove Box Light. 2nd Boot Light. Diadem Side Repeaters. LED Front Indicator, Front Side, Stop/Tail and Number Plate Lights. Bilt-Hamber Rust Treatment/Corrosion Protection.

Post Reply

Return to “How To Guides”