Frank
Member
I'll keep this short, as I'm in a rush - use a plastic pipette to squirt the Vactan into the rear arch creases and at least 2inches up each inner/outer arch Don't forget to squirt into the rear part of the arch curve from the boot. Put a spot light where the speaker housing was and you can see in the boot where your hand and pipette need to go. Do 3 coats and allow each to dry.g-whizz said:[post]362595[/post] Any other suggestions also welcome. k:
If you do have any holes, then put the Vactan in a garden sprayer and 'atomise' it in there (I didn't need to do this.)
Finish the job with 2+ coats of Dinitrol Cavity Wax, again allowing each to dry otherwise you'll 'loosen' the previous coat and it might run down. Dry anything with a COLD fan blowing inside the car.
Finally, check your speakers for sun fade/splits (easy to repair if needed) and do the rear part of the sills while you're there. The sills have a 'membrane 'middle sill in there, so be sure to get both sides.
Was in that area a few weeks back and my arch stuff is looking as good as the day I did it 3 years ago.