Selling a set of 4 alloys with nearly new tyres
5 spoke style
Perfect fitment on puma correct offset, will also fit other fords
pictures on request
collect from Derby
£80
Breaking my 1.7 puma and selling engine.
It is in perfect running order with a recent oil and filter change using 5w30 millers synthetic
will sell with ecu/loom/gearbox if required
£150 with gear box. (new clutch with receipts as proof)
Buyer to remove from car
Located in Derby
NOW £150
Ok tyres on the front and rear were bought at same time however the rear tyres need replacing already after just a few thousand miles where as fronts are fine. I get knocking when going over bumps so i assume its the rear beam brackets or top mounts? would this also be responsible for the tyre...
just played this track so loud, takes me back to a time when rock was rock
http://www.youtube.com/watch?v=Gx9SD6-a_GY&feature=related" onclick="window.open(this.href);return false;
hi,
when i go over small potholes or even just bumpy roads i get a knock/bang quite frequently almost as though ive got a flat tyre. I kicked the tyre on the rear left and it seems to have abit of play in it, now i know its not the bearings as ive just done the rears.
Im guessing its either...
hi,
when i go over small potholes or even just bumpy roads i get a knock/bang quite frequently almost as though ive got a flat tyre. I kicked the tyre on the rear left and it seems to have abit of play in it, now i know its not the bearings as ive just done the rears.
Im guessing its either...
Hi people,
I have a set of 4 puma 9spoke alloys, 3 tyres need replacing. Very slight scuffs, would make great re-furb project, very slight dent in one, does not affect balance or tyre pressures
collect from Derby
£20
Hi,
Ive got a series 10 puma its on a Y reg so 2001. Basically i want to replace the discs and pads on the front. what is the standard size disc? and is it a fairly straightforward job? ie do i need any special tools?
cheers
Are there any guides on this. Im assuming i need a turbo off a diesel? what turbo will fit to the manifold or will i need to get one made? i understand the standard 1.7 timing and fuel system is adequate for a low pressure turbo.
Any help would be appreciated.
Hi folks yet another issue regarding my HCV. basically it still wont stop blowing hot despite replacing HCV and heater control panel. Could it be anything else? Checked fuses in fuse box
Hi folks.
Been playing with the air box. I decided to ditch the side intake and enlarged the front intake similar to the frp airbox mod and ran a flexible pipe pointing down to the bumper. It feels like it works ok but seems to loose abit of top end power. Is this because i need a side intake...
Hi folks.
Bit of a strange question and i think it may be due to wheel bearings. Basically when i drive quite quick when i turn left there is a low yet quite obvious whining noise yet when i turn right at the same pace there is nothing. It sounds like its coming from the rear of the car.