Parksy87 said:Brand new batteries in the fob the key fob is working fine as in the bulb works but the puma wont go into programming mode to detect the key in the first place.
Thanks in advance
Tom
Saraimostaza said:Hi, I have exactly the same problem. After changing batteries the FOB doesn´t open the car.
(Two keys infrared key, early 98 1.7i Puma).
I tried to reprogram the remote, but when changing the contact from position 0 to I, the led in the clock stays blinking the same way it does when the car is closed or when no key inthe contact. so it never enters the programming mode.
Maybe i didn´t understand the instructions, but i think the LED must stay on after a while, then i have to turn the key from I to 0 and start with the programming procedure in front of the car sensor.
I would thank any help.
Two Button Remote
1. Put the key to be programmed into the ignition and turn to position 1.
2. After approximately 10 seconds the alarm light (next to the clock) will stop flashing and stay lit. Programming mode has now been activated.
3. Return the key to the 0 position and remove fron the ignition.
4. Aim the remote at the infrared sensor above your rear view mirror, press and hold the lock button.
5. Once the led on the remote has flashed, press the unlock button 3 times and release both buttons after a final 4th push, all the while making sure the remote is aimed at the infrared sensor. The light on the remote and on your dash will flash about 4 or 5 times to indicate the programming has been accepted.
**repeat steps 4 and 5 to program additional remotes**
6. To end programming mode, put the key back in the ignition and turn to position 1 and wait for lights to go out. Remove the key, wait and then test.
Enter your email address to join: