Ok mate, first job is remove the steering wheel shroud, you don't need to remove the wheel, I'd only done this as putting my newly recovered wheel on and replacing the silver trim. There are two smaller screws holding the top and bottom sections together, two holding the bottom shroud to the column, and then a larger screw towards the back. Next up, up the silver surround.
There are three screws for the surround, one under the plastic triangle on the far left of the silver surround, and two above the stalks. There are some clips at the bottom that will pop out and then unplug everything.
Next unscrew the single screw on the top of the stalks, lift up and unplug, then remove. It's best to have disconnected the battery before doing all this by the way, partly as you're working near the airbags, but also as you wiggle the stalks up its easy to set the horn off!
There are four screws holding the cluster itself in...
As you pull the cluster out, get a small screwdriver and pop up the clip that holds the wiring in. I have a small fetish for that clip. It works so well and as you pop it up the connector slides up. Lovely engineering for the sake of it!
Once the cluster is out, take the two pink bulbs out of the top
Then starting off at the bottom, pop out the bottom clips, stick your finger in the crack as you do it and then do the side and it will start popping apart
Then separate the two
And finished!
Do you need a new glass?