Search results

Morning, I have the 300mm setup without any spacers fitted and I have no grinding. Seems a bit strange, it should just be a straight fit, apart from opening up the bolt holes on the bracket. I thought all the calipers were the same, maybe some are different?

Afternoon all, Has anyone attempted to 'fill' the spaces in the existing mounts with polyurathane structural adhesive such as Sikaflex 252? I'm thinking of changing the mounts on my track car and I've seen a few DIY jobbies done. Providing the shore hardness is not to high (252 is only...

I want to relocate the maf sensor closer to the tb but I need to splice in cable to make the plug reach. Do you think this will make any difference to the reading from the maf? The additional resistance will be negligible over such a short distance but I don't know how sensitive the ecu is...

I'm planning on fitting an oil catch can to prevent oil vapour getting back into the inlet system but i've been thinking...instead of using the inlet vacuum could you fit an 12v pump to continuously draw a vacuum and vent the vapour to atmosphere? You could still do it through a catch tank...

I've got a question... I've currently completed stripped out the dash board and most of the heating/cooling system from the car but I can't decide whether to go all the way and remove the heater matrix too? If I did I would completely remove all the associated plumbing back to the block where...

Hello all, Just thought I'd share my wee puma project with you... There is a track day at Knockhill on the 24th of this month I hopefully going to make it to, got a bit of work to do yet though... The story so far... Full Sportex Exhaust 300mm Brake Upgrade & Stainless Lines AP...