Decided to do a update/catchup on my mods.
most of you know about my interior
heres a little graphic thread and description of what i did.
basically I removed all door cards. and got a 10m x 2m roll of grey suede off ebay (i think grey sude is a very difficult colour to come by)
To glue the suede onto the door cards, I used the dremel to rub down the plastic "rivets" which hold the door card's cloth portion onto the door card itself. after popping them off i then used PVC glue to glue them onto the standard door card's cloth.
The reason for doing this is so that I do not have to worry about the "feeling" of the cloth part being too hard as the original cloth has got a layer of sponge under it.
Doing the same for the rear I fitted the clothed trim back onto the door cards
FRONT DOOR TRIMS
[albumimg]1307[/albumimg]
REAR DOOR TRIMS
[albumimg]1305[/albumimg]
After thinking for a long time I decided to use screws and washers to fasten the clothed trim to the door trims. This was decided as I have removed the original melted plastic rivets which is part of the trim and there is no other way except to use silicone (which I think is rather messy) or the screw washer method which I think is better.
So after a trip to B&Q I came up with this
[albumimg]1306[/albumimg]
[albumimg]1308[/albumimg]
found that it is actually very firm and not loose. happy with the result I then proceeded to install them
[albumimg]1309[/albumimg]
Completed door card mod
will be proceeding onto the roof liner and A/B pillar mod nest