Mattw
New member
- Joined
- Feb 14, 2011
- Messages
- 6
Afternoon all,
Currently rebuilding a 1.7 that had the head stripped off by a garage after the belt snapped & has been sat for a couple of years since.
It's all looking pretty sweet so far, but I'm getting slightly thrown by the routing of the engine bay wiring harness. They're all in roughly the right places as certain plugs match (Crank sensor, ICV, throttle body, alternator ect) but there seems to be a couple of plugs that don't match to anything and some of the routing seem too tight/awkward.
If any of you have photos of the engine bay, particuarly around the intake manifold (big ask but underneath the manifold as well?), throttle body, coil pack (& beneath, again) and behind the O/S/F headlamp.
Huge thanks in advance, especially to anyone that goes out of their way to take some photos!
Matt
Currently rebuilding a 1.7 that had the head stripped off by a garage after the belt snapped & has been sat for a couple of years since.
It's all looking pretty sweet so far, but I'm getting slightly thrown by the routing of the engine bay wiring harness. They're all in roughly the right places as certain plugs match (Crank sensor, ICV, throttle body, alternator ect) but there seems to be a couple of plugs that don't match to anything and some of the routing seem too tight/awkward.
If any of you have photos of the engine bay, particuarly around the intake manifold (big ask but underneath the manifold as well?), throttle body, coil pack (& beneath, again) and behind the O/S/F headlamp.
Huge thanks in advance, especially to anyone that goes out of their way to take some photos!
Matt