full beam and all right indicator on? HID

[pogaz125]

Hey guys sorry but need some advice again. I fitted some HID lights that just plug straight in however when I put full beam on the right side indicators stay on constant? Please help

 

[killerpuma]

sounds like an earth problem. id take the light unit out again an double check all connections. an maybe use contact cleaner on the light unit plug.

 

[zinc2000]

As above, sounds like an earth problem.

 

[pogaz125]

Thanks zinc2000 do you know how I could resolve this;fault?

 

[pogaz125]

Sorry didn't see your other post. Iv had the light out and it was fine for 5minutes or so then straight back to fault I think your right it's definately on the connector light unit plug

 

[zinc2000]

Check for any trapped wires when you replace the light or with the light in place and on hold/waggle each wire going to the connector, see which one if any bring on the indicator, could be a loose connection/frayed wire etc
Also check any earth wires nearby, clean tighten as needed

May be a bit of trial and error involved....if all else fails you might need to replace the entire connector