hewy
New member
I thought I would show my cat C Puma 1.7 I bought in Car Transplants in Winsford, Cheshire for £250. The pictures were taken after the passenger door and wing replacement as well as the A Frame where the hinges are fitted on and the welding on the floor pans in the front, which I didn't knew till I removed the seats and carpet. Also the bonnet was replaced with a better one because the old one was scratched really bad.
These are the pictures of passenger side of the door and wing that replaced the dented parts. The wing was fitted by myself but the door and pillar repair was done by a body shop.
These are the scratches on the drivers side and a bit of surface/bubble rust on the rear arche. This will be dealt with after the VIC and MOT. I seen the marks when I went to see the car but didn't knew about the rust on the arch till I had it.
The ABS Sensor on the passenger side needs looking at because I had the wheel off when I was replacing the wing and might of knocked it or might be dirt in the plug. Even I may have to replace it. I took for a spin around the block and the ABS/Traction Control lights on the dash didn't turn off when I went over 15mph. I might also replace the discs and pads just to make sure.
Here is the list and costs of the jobs been done and that have to be done:-
Jobs Done:-
Car £250
Door £30
Wing £20
Bonnet £30
Drivers Wing Mirror £10
Door Fitting and Pillar Repair £150
Floor Welding £120
Car Transportation To & From Body Shop £70
Fitted In Ripspeed 723b Headunit And Cables Free
2 New Tyres £86
Refitted Rear View Mirror £4
Jobs Got To Be Done:-
Respray Center Caps
ABS Sensors
Arch Repair
Respray Over Scratches
MOT
VIC
Tax
Fit in Amp, Bass Speaker and Cables
Get It Valeted Properly.
I hope to get it on the road by June ready for the hot weather and before my runabout's tax and mot run out.
These are the pictures of passenger side of the door and wing that replaced the dented parts. The wing was fitted by myself but the door and pillar repair was done by a body shop.
These are the scratches on the drivers side and a bit of surface/bubble rust on the rear arche. This will be dealt with after the VIC and MOT. I seen the marks when I went to see the car but didn't knew about the rust on the arch till I had it.
The ABS Sensor on the passenger side needs looking at because I had the wheel off when I was replacing the wing and might of knocked it or might be dirt in the plug. Even I may have to replace it. I took for a spin around the block and the ABS/Traction Control lights on the dash didn't turn off when I went over 15mph. I might also replace the discs and pads just to make sure.
Here is the list and costs of the jobs been done and that have to be done:-
Jobs Done:-
Car £250
Door £30
Wing £20
Bonnet £30
Drivers Wing Mirror £10
Door Fitting and Pillar Repair £150
Floor Welding £120
Car Transportation To & From Body Shop £70
Fitted In Ripspeed 723b Headunit And Cables Free
2 New Tyres £86
Refitted Rear View Mirror £4
Jobs Got To Be Done:-
Respray Center Caps
ABS Sensors
Arch Repair
Respray Over Scratches
MOT
VIC
Tax
Fit in Amp, Bass Speaker and Cables
Get It Valeted Properly.
I hope to get it on the road by June ready for the hot weather and before my runabout's tax and mot run out.