Recent content by SkyHighatrist

Silver, fully operational, doesn't skip or jump. £20 collected from Wolverhampton, or can post for cost of postage. 07938 104352 if interested.

What ''deal'' would you do on the alloys? I have a set of 16" Fiesta Zetec, slight damage, if you'd be interested in those??

I put a set of Fiesta Zetec alloys on mine to get it through an MOT. Was either re-tyre the old scraggy 15's i had on there initially, or buy this set. Offset is way out there though at 52.5 so i've had to rectify with spacers. Still rubs on full lock at the front and looks way too slim at the...

I dont know, until i had the engine transplant last year, my millie hit about 73 in second on std 15"s. Now she does barely make 60 in 2nd :/

I have the same problem. When I hit the button I can hear the solenoid working but it doesn't open up the boot. However, I have found that if i ''bounce'' a little on the bootlid whilst pressing the open button, it opens up eventually.

Took mine to TLC Ford in Coseley in June for an engine swap after my bottom end bearings went. £450 for an 85k engine supply and fit.

Heya J-Lo :lol: i'm just up the road in Wolverhampton. Drive a millennium so not too difficult to spot. Usually come through cannock as I work out of the container yard some days.

Looks good to me. Down from £279 to £129 . . . Bargain :ok:

From what advice I've seen given on here, the Puma is a Fiesta with a pretty dress on. So with regards to your question, bits should swap ok. And FFS keep the Puma!! !!

I'd say so yes, I have ET52.5 on mine and they are too close for comfort but still run ok. Didnt get pulled up on the MOT so ET38 should be fine

Whats the thread length for the Puma? Ive fitted a set of 16's off of a Fiesta Zetec with spacers, but they still sit too close to the shocks and right inside the arches. Makes her look really skinny. I'm hoping that if i get a longer thread, i'll be able to fit bigger spacers thus bringing the...

Scratch that last post. Eff me they are close at the rear, not close enough to cause damage though. As for the front, they went on but under 3/4 lock, they started rubbing very slightly. 5mm spacers and they fit :thumbs: Probably knackered all the handling etc up but i only need them to...

Answer - no . . . . They are a ET 52.5 offset and from a local tyre / alloy refurb place, it'll be around £200 to make them fit :'(

Will these go on my millie? http://www.ebay.co.uk/itm/Ford-Fiesta-16-Alloy-Wheels-/320995255692?pt=UK_CarParts_Acc_Wheels_tyres_Rims_Car_Wheels_ET&hash=item4abccee58c Hope so because the ones im buying will be taking her through the MOT tomorrow. Thanks in advance