mrMechanix
New member
Decided it would be faster and easier to just put it back to silver inside.
pic of rear after prep. de-tar, clean, scuff all with scotchbright then cleaned again before masking.
inside painted, 2 coats of primer, 3 silver, 3 clearcoat.
Next is under the engine bay.
Battery tray support structure removed
Bonnet catch mounting plate on front panel removed.
these arrived yesterday. once thier silver and the graphics are on, i think they'll look ok. sellotaped them on for a quick peek. fit pretty good too. not much modification required. you have to try to imagine the car being about a foot lower with wider bigger wheels tho.
Two weeks into my five week schedule and im almost finished with the shell prep. final few bits and bobs will be removed from the engine bay tomorrow, then the bay can be painted. after that its just a case of putting it all together. :grin:
pic of rear after prep. de-tar, clean, scuff all with scotchbright then cleaned again before masking.
inside painted, 2 coats of primer, 3 silver, 3 clearcoat.
Next is under the engine bay.
Battery tray support structure removed
Bonnet catch mounting plate on front panel removed.
these arrived yesterday. once thier silver and the graphics are on, i think they'll look ok. sellotaped them on for a quick peek. fit pretty good too. not much modification required. you have to try to imagine the car being about a foot lower with wider bigger wheels tho.
Two weeks into my five week schedule and im almost finished with the shell prep. final few bits and bobs will be removed from the engine bay tomorrow, then the bay can be painted. after that its just a case of putting it all together. :grin: